let’s get SET UP.
Your new RealGood Glory Hole only takes a few minutes to get up and running.
With proper care and attention to safety, your RealGood Glory Hole will last you for years.
iNCLUDED IN YOUR BOX:
1 RealGood Glory Hole
4 m8 hanger bolts
4 m8 STAR KNOB cLAMP NUTS
1 toP BOLT marking GUIDE
Step One
Take note of the 4 pre-drilled holes A, B, C, D. These correspond to where you will be installing the included hanger bolts into the doorframe.
You will want to use the included Top Bolt Marking Guide to mark with a pen or marker on the doorframe where you will be installing the top two bolts. It comes pre-measured for your order.
It should be positioned with about 6-8 inches of clearance from the top of the doorframe.
Step TWO
Using a hammer and Torx screwdriver (or drill bit), install the top two hanger bolts into the doorframe in positions A and B.
Leave about 3/4 inch of the hanger bolt exposed and ensure they are level so that the Real Good Glory Hole is not crooked when hanging.
Note: Ensure the top two hanger bolts are installed in the correct positions to match exactly where the top two precut holes on the RealGood Glory Hole are! Use your included mounting guide to pre-mark where to install the top two hanger bolts!
Step three
Slide the RealGood Glory Hole onto the top two hanger bolts, and ensure that is level and at an appropriate height.
Fasten using two of the M8 Star Knob Clamp Nuts.
Step four
Install the last two hanger bolts into the doorframe in positions C and D.
You do not need to use the mounting ruler for this step if you leave the Glory Hole hanging by the top two installed bolts. The bottom half with the pre-drilled holes will rest against the doorframe where you need to install the last two bolts.
Fasten using two of the M8 Star Knob Clamp Nuts.
That’s it!
You’re ready to use your RealGood Glory Hole.
